Veo Observer Plus Instruções de Operação Página 111

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 110
Charged Aerosol Detectors
Corona Veo and Corona Veo RS
Operating Instructions Page 103
Problem Probable Cause Remedial Action
Spikes Electrical interferences from other
modules.
Isolate the electrical circuit from
strong current consumers. Consider
using an UPS (Uninterruptible
Power Supply) to filter current
fluctuations.
Ground the detector using heavy
gauge wire from the thumbscrew
ground terminal that is located on
the power supply module to the
main power ground.
The column temperature is
significantly above boiling point
of the mobile phase.
Use a post-column cooler or reduce
the column temperature.
Negative Peaks Sample solvent and mobile phase
differ in composition.
Dissolve the sample in the mobile
phase.
Wrong polarization of the analog
output interface.
Check the analog output
polarization.
Loss of response Analytes of interest are not
sufficiently stable.
Some compounds will decompose
as a function of time.
Check the stability regularly, and
prepare fresh standards. If
necessary, change conditions.
The pH of the solvent or the
mobile phase composition has
been changed.
Check the mobile phase.
Mobile phases should be freshly
prepared.
Use a fresh mobile phase.
A parameter has accidentally been
changed.
Check the settings and verify that
the detector is turned on and data
acquisition is started.
Autosampler components may be
partially or fully clogged.
Make sure that the sample and
mobile phase are clean.
Flush the autosampler
( Autosampler Manual).
The stream-switching valve
(SSV) is in the divert position
(Corona Veo RS only).
Make sure that the SSV is directing
liquid to the nebulizer.
The drain pump of the detector
has failed.
In the System Setup menu, make
sure that the drain pump is turned
on. If there is excessive gas venting
from the Waste port, contact
Service.
Vista de página 110
1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 143 144

Comentários a estes Manuais

Sem comentários